SEO Header Title

Work table i made for working outside, i covered it in plastic to protect the wood in case it rained.

 ok yesterday i made a work table outside as its really nice out plus i dont have enough room in my shop , today i laid out the bottom hull panels.

The second Muscoda HoverIn is just days away! 

Well things have went slower then I hoped again. Just have to plastic off the back and hopefully tomorrow I can spray. Here are some pics of it so far.

Who checks it?

 I know this has been discussed many times on this site and other sites I have visited over the years. All of the information is on a foam duct but what is so different about my problem is that the entire duct is made of wood 3ply 1/8" marine plywood on the in side and a rib placed every 12" and then 3/16" veneer on the out side. 

I would like some input on why this happens and how to repair this problem.

That's right, the creativity got out of control and I made my trim wing different from the normal rectangular shape.  Keeping with the "angled" motif of Valkyrie, and with a nod to Adam West (the BEST Batman, IMO), my trim wing has some angular shapes in it.

Hello, Well I spent some time in the last week prepping for paint. I have the week off of work for a little mid summer down time. I layed down a base coat of grey last Sunday to even everything out. I waited a few days to let that cure out and yesterday I got it ready for the top coat.